06-24-2024, 05:26 PM
(06-24-2024, 05:13 PM)Mozart Wrote: Also, shrinking compound while is cooling down introduce mechanical stress in electrodes albeit is very small but act like fine tuning for musical instruments … if you consider to modulate.
The whole point is to obtain isolation between the 2 state of manifestation of electricity … any 2 states, where conversion from 1 state to another state can take place in 1 way only.
I think I wasn’t clear enough but I will clarify now: I am not suggesting to replace Joel cell with my type water based, I am saying the water based can be used to rise the potential and they replenish themselves, if you need just potential 10-20 cells of magnesium+copper in distilled or deionised water may be enough, where each cell may provide 1.4-1.6 v with 2-3 cm of magnesium ribbon and 0.5 mm magnet wire or copper foil of 3-4 cm long same width and thickness … they will last in this way very long time and cost maybe £10-20 for 20 cells.
Due to low amps I can think of optocouplers darlington output for switching (with high gain) … also pretty cheap. All the rest can be as usual inductors for next stage
Sure if you want to replace the series chemical cells with just water cells it will work as well. As long as there is at least one peg cell in the series to keep the loop open at DC.