10-30-2023, 11:07 AM
(This post was last modified: 10-30-2023, 01:33 PM by alexinspire.)
Thank you Joel. I ordered the microwave caps. I will look for the x rated caps too. Probably easier to work with because of its size.
@admin,
If I follow the schematic of exactly, the neon will blink dimly and shortly. I tested it with 10,000uf caps and the voltage increases. My only issue is that the output is very low and takes a really long time to increase 0.01v of a small battery. My main concern is that the coil is not generating much back emf. I am not sure if it’s because:
1) coil connected wrongly: I twisted all 4 cores together at both end.
2) the cables are not thick enough: my phone cable is 0.63mm each
3) other reasons that I am not aware of
I managed to fit everything in a connector ?
https://drive.google.com/file/d/1exuQSAr...p=drivesdk
@admin,
If I follow the schematic of exactly, the neon will blink dimly and shortly. I tested it with 10,000uf caps and the voltage increases. My only issue is that the output is very low and takes a really long time to increase 0.01v of a small battery. My main concern is that the coil is not generating much back emf. I am not sure if it’s because:
1) coil connected wrongly: I twisted all 4 cores together at both end.
2) the cables are not thick enough: my phone cable is 0.63mm each
3) other reasons that I am not aware of
I managed to fit everything in a connector ?
https://drive.google.com/file/d/1exuQSAr...p=drivesdk