http://typeright.social/forum/ Tue, 14 Apr 2026 11:54:10 +0000 MyBB http://typeright.social/forum/showthread.php?tid=528 Thu, 23 Oct 2025 01:11:07 +0200 vnachow]]> http://typeright.social/forum/showthread.php?tid=528 All about the Unified theory you can find in the PDFs attached.

About the magnet flux modulator(transistor), it works better than shielding

For example we take a good big horseshoe (steel one) and we attach paralel to it some powerful neodymium stick. Then just after it we bring in a small winding. A tiny bit of voltage is needed to simply modulate the magnetic flux within the ferromagnet, it shifts the gradient so the center of the flux shifts, when this shifts then the attraction power of one pole becomes spread out on the longer part of the ferrite, the smaller part (after the coil) gets super concentrated flux gradient and attracts stronger at the tip. So basically we oscillate our time polarized flux (magnets i call time batteries) with a tiny resonant switch. Then the rest is easy, a V gate, flywheel, generator, detector, transistor, batteries, switch.
I also attached a rough sketch image of the gauss flux transistor

  Unified.pdf (Size: 133.7 KB / Downloads: 12)

  Unified Vol 3 - The Golden Egg.pdf (Size: 93.38 KB / Downloads: 10)

  the-consciousness-cube.pdf (Size: 614.31 KB / Downloads: 8)

  Unified Vol 2.pdf (Size: 102.94 KB / Downloads: 10)

  file_00000000439462468431eba4a32e17c9 (1).png (Size: 1.46 MB / Downloads: 67) ]]> All about the Unified theory you can find in the PDFs attached.

About the magnet flux modulator(transistor), it works better than shielding

For example we take a good big horseshoe (steel one) and we attach paralel to it some powerful neodymium stick. Then just after it we bring in a small winding. A tiny bit of voltage is needed to simply modulate the magnetic flux within the ferromagnet, it shifts the gradient so the center of the flux shifts, when this shifts then the attraction power of one pole becomes spread out on the longer part of the ferrite, the smaller part (after the coil) gets super concentrated flux gradient and attracts stronger at the tip. So basically we oscillate our time polarized flux (magnets i call time batteries) with a tiny resonant switch. Then the rest is easy, a V gate, flywheel, generator, detector, transistor, batteries, switch.
I also attached a rough sketch image of the gauss flux transistor

  Unified.pdf (Size: 133.7 KB / Downloads: 12)

  Unified Vol 3 - The Golden Egg.pdf (Size: 93.38 KB / Downloads: 10)

  the-consciousness-cube.pdf (Size: 614.31 KB / Downloads: 8)

  Unified Vol 2.pdf (Size: 102.94 KB / Downloads: 10)

  file_00000000439462468431eba4a32e17c9 (1).png (Size: 1.46 MB / Downloads: 67) ]]> http://typeright.social/forum/showthread.php?tid=332 Fri, 02 Feb 2024 15:46:09 +0100 Mozart]]> http://typeright.social/forum/showthread.php?tid=332
Now, I am looking for some logic and coherent explanations as why we get a voltage from 2 dissimilar metals when they are immersed in water like aluminium and copper or iron and copper (Bagdad battery). Why and how can we use only ONE electrode of such batteries ?

Also, why electricity is generated when 2 similar metals are immersed in drinkable water like small wire of copper and large wire of copper or aluminium or iron ?

Also i found out that if we immerse an electrolytic capacitor in drinkable water is start to charge itself up to a certain voltage. So to short out an aluminium electrolytic cap 10 V 100 uF for 5 minutes to make sure there is no charge whatsoever, then we just put it in a glass of water or plastic recipient. We can use 2 methods to make sure this is not galvanic reaction: connect multimeter to each end of cap then put it in water or just put the cap in water then after few seconds or few hours (makes no difference) we take it out and measure the voltage.

Now to make everything even more intrigue we take a diode like sbyv27-200-E3/73 200V 2.0 A 15 ns connect its ends to multimeter then immerse in a glass of drinkable water and start to show up voltage !

Now, if we don’t have enough headache we can just twist the ends of cap with the diode and put them in drinkable water … than just stick your multimeter probes in the water  … this is just mind blowing …

Anyone may try some explanations ? Or anyone want to try the same or even adding resistors to this headache ?

By the way i just had a look at Tesla patent US514168A from 06/02/1896 -Means of generating electric current … with capacitors immersed in oil … but i am not using any power source nor induction or whatever in setup described above … I am puzzled

I need to make another cell to make room for a cap underneath the 2 coiled copper and aluminium wires in a plastic tube to see where this lead to.]]>
Now, I am looking for some logic and coherent explanations as why we get a voltage from 2 dissimilar metals when they are immersed in water like aluminium and copper or iron and copper (Bagdad battery). Why and how can we use only ONE electrode of such batteries ?

Also, why electricity is generated when 2 similar metals are immersed in drinkable water like small wire of copper and large wire of copper or aluminium or iron ?

Also i found out that if we immerse an electrolytic capacitor in drinkable water is start to charge itself up to a certain voltage. So to short out an aluminium electrolytic cap 10 V 100 uF for 5 minutes to make sure there is no charge whatsoever, then we just put it in a glass of water or plastic recipient. We can use 2 methods to make sure this is not galvanic reaction: connect multimeter to each end of cap then put it in water or just put the cap in water then after few seconds or few hours (makes no difference) we take it out and measure the voltage.

Now to make everything even more intrigue we take a diode like sbyv27-200-E3/73 200V 2.0 A 15 ns connect its ends to multimeter then immerse in a glass of drinkable water and start to show up voltage !

Now, if we don’t have enough headache we can just twist the ends of cap with the diode and put them in drinkable water … than just stick your multimeter probes in the water  … this is just mind blowing …

Anyone may try some explanations ? Or anyone want to try the same or even adding resistors to this headache ?

By the way i just had a look at Tesla patent US514168A from 06/02/1896 -Means of generating electric current … with capacitors immersed in oil … but i am not using any power source nor induction or whatever in setup described above … I am puzzled

I need to make another cell to make room for a cap underneath the 2 coiled copper and aluminium wires in a plastic tube to see where this lead to.]]>