https://youtu.be/fkAQfP6bTSc
Same circuit in different configuration.
4 batteries 12 V 7 ah SLA used extensive to power this circuit only wired 2 parallel 2 series gives 24 V 14 ah. After few weeks of exclusive usage with this configuration have a resting voltage of 13.10 V old pack and respective 13.30 V after 6-7 hours resting after charging. Many of you will say they experience surface charging … I want to remind you that surface charging will not sustain the voltage under load ! They are used daily for continuous 1-2 hours and they are drawn to 80-60%, occasionally they were used 2 times for continuous 6 hours with approx 100 W load. Manufacturer specification indicate C20 which means in this case 0.750 amps continuous drawn. Circuit used with 100w load draw about 2 amps as seen in videos and even exceeding to 4.4 amps for periods of 30 minutes … yet, batteries are healthy and improving their capabilities by the day.
Circuit is not shielded and no HF suppression is used ! HF is present on every point in this circuit and surrounding proximity, so, batteries will never get the opportunity to sulfate and clog their electrodes.
Also, in videos is shown self adjusting oscillation frequency and behaviour under load with restricted input (high resistance/impedance source or, sources with very little current availability) and with less restricted input (governed by internal resistance of batteries)
More tests will be shown soon on the channel with open circuit on AC output rectified for easy and more precise measurements, different types of usage, methods of scaling up and quantified input/output along with free existing electric power available. Once capabilities of circuit are known we can design adequate methods of capture of free exiting potential for desired output.
Output can be used without transformer or any methods to step down voltage ! The circuit can power up 240 Vac loads or 24 Vdc loads using sigle wire power transmission through the earth.
https://youtu.be/mP0HjeavvoQ
Field tests out in the nature, away from power lines coming soon ! Please let me know your thoughts or if anyone needs more details or explanations … everything is free to use/share, non patentable !
For domestic/industrial appliances/devices output should be rectified and smoothed with dc link capacitors (high voltage) and than placed into an off grid inverter … this circuit output is not suitable for inverters that need to see AC from grid ! It is pure OFF GRID ! Inverter to be used for AC MUST NOT ⚠️ try to sense/quantify the dc input, only needs to accept the DC input !
Observe the 2 pictures attached and try to imagine fractal collector designed by N Tesla placed in the electrostatic field of the Earth. Primary should not deliver full power needed by the loads, it has the only role to swing/hit hard free existing potential between earth/ground/counterpoise and elevated collector able create electric pressure (voltage).
When N Tesla refer to ionosphere actually he made reference to ionisation (polarised electric charges) taking place at collector. His clever design allow a safe self discharge direct at collector level (St. Elmo’s fire) when voltage of atmospheric electricity reach high level. Different designs for collector can be observed without self discharge protection needs an additional line with a spark gap or different methods (gas discharge tubes etc.) to protect the circuit as seen in Patrick Kelly book, chapter 7-aerial systems !
